User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 103 10-Dec-12
Blocking the SIP caller with anonymous caller ID such as anonymous@anonymous or a similar
address will result in blocking all SIP callers with unknown caller address.
12.2.6 Call Routing Management
Dial , to manage the routing entries in the Call Routing Table, i.e. to enable/disable certain
dialing rules by dialing key combinations pre-configured on each routing entry. Since multiple
routing rules may have the same enabler/disabler key combinations (the same key may be used
as an enabler for one routing rule, and as a disabler for another one), dialing a certain key will
affect all the pre-configured routing rules.
Please Note: If the routing record has an authorization enabled on the enabler/disabler key,
administrator's password will be required to be inserted after the key. Once the administrator's
password is dialed, system plays a confirmation about the accepted configuration and the state of
the optioned routing rule(s) will be modified.
If administrator's password has been inserted incorrectly for 3 times, no status changes will be
applied to any of the routing record(s), even to those which have no authorization enabled.
12.2.7 Hot Desking
To login or logout to the public phone dial .
Dial the virtual extension number and press #.
Dial the password and press #.
After login, the phone becomes a full featured Quadro phone with all supplementary PBX features
available. When logged out, the public phone becomes available for other users to login and the
extension which has been last used on that phone becomes again virtual. For more details on the
functionality, see Hot Desking.
12.2.8 To Configuring outgoing call blocking from handset
Dial . Insert the extension's password and press #1 to block or #2 to unblock a number.
Dial a Called Number to be blocked and press #. Dial a Called Number to be unblocked and press
#
12.2.9 Mark the Last Call as Bad
Dial  after finishing the call. This will mark the last call in the system logs in the specific
way and is used for diagnostics purposes only).
12.2.10 Logs Collecting (this will generate a special user's failure log
with the details of the last call for administrator's revision)
The Logs Collecting feature code  is used in the cases your administrator has advised you.
You will get the dialtone after this feature code is dialed.