User`s guide

Epygi Technologies Quadro Features on Epygi Tested IP Phones List
PAGE 102 10-Dec-12
12.2.1 To Use Busy Auto-redial
This service is functional for SIP and PBX calls only. For PSTN calls, this feature works as a single redial with no
multiple attempts to reach the called destination.
Dial
 to redial the last number that you called.
If the called number is busy after dialing
, keep the handset lifted to activate the automatic
redialing of the last called number for the time period specified on the Auto-redial Settings page
(User login Supplementary Services->Basic Services->General Settings).
The auto-redial terminates as soon as:
• the called number is idle and you hear ring back tones
• the specified Auto-redial Period has expired
A beep sound will be heard if auto-redialing is not possible.
12.2.2 To Call Back
Dial . The system will call back the last caller.
"The dialed number doesn't exist" voice message will be played if call back is not possible.
12.2.3 To Activate and Configure Unconditional Call Forwarding Service
If preliminarily configured:
• dialling
 will activate the Unconditional Call Forwarding service with the settings
specified for Any Address/Other Addresses on the Caller ID Based Services page
(User login Supplementary Services). Use the same key combination to deactivate the
service.
• dialling
 will toggle (enable or disable) the Unconditional Forwarding service.
• dialling
 will change the forwarding number
Please Note: If no preliminary configuration is available dialling
 will not change the state of
the service instead you should press
 to add a forwarding number
12.2.4 To Switch Do Not Disturb Mode
Dial  and hang up. Your phone will not ring during the period indicated on the Do Not
Disturb Settings page (User login Supplementary Services->Basic Services) and all incoming
calls will be directly forwarded to your voice mail if the voice mail service is activated.
Use the same key combination to deactivate the DND service.
12.2.5 To Block Last Caller
Dial . The last caller will be blocked and a corresponding entry will be added to the Caller
ID Based Services (User loginSupplementary Services) page.
Attention: This service can be activated within 10 seconds after call termination. To unblock the
blocked party, go to the Caller ID Based Services page and disable the Incoming Call
Blocking service for the blocked address. If no other services are enabled for the address, you
may delete the entry from the table.