Specifications

Temporis IP 200 Administrator Guide ed 1.0 - 76 - / 109
server cannot be enabled.
Start IP Address DHCP server pool start IP address.
End IP Address DHCP server pool end IP address.
To configure PC Port settings via Phone interface:
1) Make sure active User type is admin or var
2) Press ->3.Settings->2.Advanced->OK.
3) Enter the password required, scroll to Network option, press OK button and select
PC Port option, then press OK button to enter.
4) If you choose Bridge, it will return to the previous menu.
5) If you choose Router, you will be prompted to enter the IP, Subnet Mask, DHCP
Server Disable/Enable.
6) Press OK button to save the changes, or MENU to return to the previous menu.
To configure PC Port via Web interface:
Choose Network->PC Port to do necessary changes. Please note start and end IP
address can only be set via Web interface. Check with your system administrator for
more information.
Advanced Network Settings
LLDP
The Link Layer Discovery Protocol (LLDP) is a vendor-neutral Layer 2 protocol that
allows a network device to advertise its identity and capabilities on the local network.
If LLDP function is enabled the phone will go to try a get related VLAN parameters
automatically from the switch. (Synchronous with VLAN in switch)
To configure LLDP settings via Web interface:
Go to Network->Advanced->LLDP->Active option. In the pull-down menu, choose
Enable.
Then enter the corresponding Packet Interval in Packet Interval field.