User`s guide

Standard wiring
procedure
Single PC wiring
1 Alcatel Speed Touch 510 Installation
9 / 34
3EC 36511 AAAA TCZZA Ed. 02
Proceed as follows:
1. Use the included LAN cable to wire your PC's Ethernet port to (one
of) AST510's Ethernet interface(s).
2. For local networking, repeat step 1. for each PC. Use a hub/switch
if needed.
Note: You may use the (switchable) uplink" or cascade" MDI port which
is sometimes present on Ethernet hubs or switches. However, make sure to
use the correct cable type.
3. Use the included DSL cable to wire the AST510's Line port to your
telephone wall outlet.
4. Plug the adapter's coaxial jack into the AST510's receptacle
marked 'DC'.
Note: Always check first whether the included mains adapter suits the
local power specifications. Contact your Service Provider in case of any
doubt.
AST510 hub model vs switch model - Cascading hubs
You may cascade up to four repeating hubs in your LAN. In case more
hubs need to be cascaded, you must use a switch, e.g. the AST510
switch model.
10BaseT Half Duplex Interfacing
Make sure in case you use 10BaseT Ethernet port(s) on your PC(s) that
these are configured for either Auto Negotiation or Half Duplex.
Never configure the 10BaseT Ports for FullDuplex !
Once all connections are made the result should look similar as below.
WARNING
CAUTION