User`s guide
Overloading
Servicing
Damage requiring
service
Modem/Telephone use
Modifications
EC Declaration of
Conformit
y
AppendixB Safety and Agency Regulatory Notices
33 / 34
3EC 36511 AAAA TCZZA Ed. 02
Do not overload wall (mains) outlets and extension cords as this
increases the risk of fire or electric shock.
To reduce the risk of electric shock, do not disassemble this product.
None of its internal parts are userreplaceable; therefore, there is no
reason to access the interior. Opening or removing covers may expose
you to dangerous voltages. Incorrect reassembly could cause electric
shock if the appliance is subsequently used.
If service or repair work is required, take it to a qualified service dealer.
Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled into the product.
If the product has been exposed to rain or water.
If the product does not operate normally.
If the product has been dropped or damaged in any way.
If the product exhibits a distinct change in performance.
Avoid using a modem/telephone (other than a cordless type) during an
electric storm. There is a slight risk of electric shock caused by lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
If telephone service is required on the same line, a central splitter or
distributed filter(s) must be installed for optimal ADSL performance.
Depending on your ADSL configuration and type of splitter/filters,
installation must be carried out by qualified service personnel.
Consult your telephone service company or ADSL service provider for
instructions.
Changes or modifications not expressly approved by Alcatel could
invalidate the users authority to operate this equipment.
Products with the marking comply with both EMC and Low Voltage
Directives issued by the Commission of the European Community.
Hereby, Alcatel, declares that this Alcatel Speed Touch product is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.