User`s guide

How to perform a
hardware reset to
factory defaults
Factory default settings
ADSL specifications
AppendixA Troubleshooting and Specifications
30 / 34
3EC 36511 AAAA TCZZA Ed. 02
Proceed as follows:
1. Make sure your AST510 is powered on.
2. Use a pencil to press the push button at the back of the AST510
until the all front LEDs start flashing.
3. Release the button. You will notice that the AST510 reboots.
The AST510 will come online with factory default settings.
4. As a reset to factory default settings also includes a deletion of the
configuration profile settings. Therefore, a reconfiguration via the
AST510 Setup wizard or via uploading the appropriate
configuration file might be needed. See section 1.3 for more
information.
When the AST510 leaves the factory and after every hardware reset to
defaults the AST510 features following factory default settings:
 Default IP configuration:
 AST510 IP address: 10.0.0.138
 AST510 System password: not set
 AST510 DHCP server: disabled
 AST510 DNS server: disabled
 AST510 master firewall: enabled
 Default Connection profile settings:
 IEEE802.3D Transparent Bridging on VPI*VCI=8*35
 IEEE802.3D Transparent Bridging on VPI*VCI=0*35
 ADSL data rates
 Downstream user (payload) data rates:
Up to 8Mbit/s, depending on provisioning
 Upstream user (payload) data rates:
Up to 1Mbit/s, depending on provisioning
 ADSL/POTS standards compliancy
 ITU(*) G.DMT (Full rate ITU G.992.1 Annex A)
 ITU G.LITE (Lite rate ITU G.992.2)
 Full rate ANSI T1.413 Issue 2
 ITU Automode
 ADSL/ISDN standards compliancy
 ETSI TS 101 388
 ITU G.DMT (Full rate ITU G.992.1 Annex B)
 ITU G.Handshake (Automode ITU G.994.1)