User`s guide
Supported OSs
TCP/IP
Procedure
1 Alcatel Speed Touch 510 Installation
16 / 34
3EC 36511 AAAA TCZZA Ed. 02
1.3.2 Configuration Setup for other OSs
As the AST510 is OS independent, this configuration setup can be used
by any computer system
Note: In fact the following procedure may equally be used on MS Windows
OSs for configuring the AST510.
Make sure that TCP/IP is installed on your computer(s).
Configure every PC with a static Net10 private IP address, e.g.
10.0.0.1. Make sure though NOT to use the 10.0.0.138 IP address as
this is the default IP address of the AST510.
To make sure that IP connectivity exists, you can ping the AST510.
1. To make sure that the AST510 is in its factory default state,
perform a reset to defaults. See appendix A.
2. Open a web browser and browse to the AST510 's default IP
address 10.0.0.138. See chapter 2 for more information.
3. Click
Upgrade to open the Upgrade web page.
4. Click
Browse next to the Configuration file path input field to locate
the configuration file on the CDrom or disk.
Note: If the path is known you can immediately enter it in the
Configuration file path input field.
5. Click
Upload to start the upload.
6. Click
Restart to restart the AST510 and activate the uploaded
configuration.
7. After restarting the AST510 some additional configuration of your
computer system might be needed.
Note: The required settings for your computer should be provided
by your Service Provider, if applicable.
8. To check whether the activation of the uploaded configuration was
successful, you can browse to the AST510 and overview the
current configuration.