User`s guide

The configuration
procedure
1 Alcatel Speed Touch 510 Installation
14 / 34
3EC 36511 AAAA TCZZA Ed. 02
6. The setup wizard should find your AST510 device on the local
network. This is indicated by following window:
Note: In case the Setup wizard does not find any AST510 on the
network an error window pops up. In this case check:
 Whether your PC is correctly wired to the AST510
 That no dedicated firewall device or a router is placed
between your PC and the AST510 and that no personal
firewall software is running on your PC
 Whether the AST510 is powered on and fully initialized
 That you have the Internet Protocol (TCP/IP) installed on your
PC, and that your PC is configured with a valid IP address(*).
To retry the detection of the AST510, click and proceed
with step 5. of this procedure.
(*) In case of MS Windows 95 or Windows NT4.0 it is advised to configure
the PC with a static IP address, e.g. 10.0.0.101, which is unique (in case
of a local network). Make sure however not to use the 10.0.0.138 IP
address as it is the AST510's default IP address. For the MS Windows 98,
98SE, ME, 2000 and XP OSs it is advised to configure the PC as DHCP
client. Refer to the MS Windows User's Guide for more information.
7. To continue with the configuration of your AST510 and your PC,
proceed with the configuration procedure described below
1. As soon the AST510 Setup wizard detected your AST510 device
you are able to select it.
Click
to proceed.
Note: In case the AST510 has been configured before, the
possibility exists that it is protected by a System password. Before
you are able to overview the device details or to continue with the
configuration this password has to be supplied.