User`s guide

Introduction
Procedure
9 Maintenance - Speed Touch ToDefaults
79 / 104
3EC 17058 AAAA TCZZA Ed. 04
9.2.3 SwitchtoDefaults
At the back of the STHome there is a small push button labeled
"Defaults".
Via this button a hardware reset of the STHome, the
SwitchtoDefaults, is possible.
Proceed as follows:
1. Make sure your STHome is turned on.
2. Use a pencil to press the push button at the back of the STHome.
3. Release the button. Via the flashing front panel LEDs, you will
notice that the STHome will reboot.
Wait to allow the POST to end. The STHome will come online
with manufacturing defaults.
4. After a reset to original defaults a reconfiguration of
STHome's IP address might be necessary. This because the
reset to defaults also resets your STHome's IP address to its
default value 10.0.0.138.