User`s guide
PPPoAtoPPTP
Relaying configuration
Creating a PPTP
connection icon
2 Speed Touch Configuration Guide
31 / 104
3EC 17058 AAAA TCZZA Ed. 04
2.3.5 PPPoAtoPPTP Relaying Packet Service Configuration
Per default, following PPTP phonebook entries are available for
PPPoA/PPTP connections:
RELAY_PPP1 (PPTP on 8.48)
RELAY_PPP2 (PPTP on 8.49)
RELAY_PPP3 (PPTP on 8.50)
RELAY_PPP4 (PPTP on 8.51)
In case these PPTP phonebook entries do not meet your
requirements, you can configure a new one as follows:
1. If needed, add a PPTP phonebook entry with the correct
VPI/VCI on the 'Phonebook' page.
2. On the 'PPTP' page, select this phonebook entry from the
'Name' popdown list.
3. For this entry, select the correct encapsulation method.
4. Optionally, select the type of HDLC Framing.
Note: Only in very exceptional cases the default HDLC framing (Never)
must be altered.
5. Click and to finish the procedure.
Most PPTP Tunneling applications provide a Graphical User
Interface (GUI) guided procedure for the initial creation of a PPTP
session icon.
The result of such creation is in most cases an icon or entry in a
folder or a table called 'RAS', 'DialUp Networking', 'PPTP', 'Call
sessions', 'Remote Access', etc.