User`s guide
STHome access
Accessing the STHome
2 Speed Touch Configuration Guide
25 / 104
3EC 17058 AAAA TCZZA Ed. 04
2.3.1 STHome Web Interface Access
The STHome features well chosen defaults. Therefore, in most
cases no additional configuration is needed for immediate Internet
connectivity.
In exceptional cases additional or advanced configurations are
desired, the STHome offers a userfriendly web interface.
Note: You can also configure the STHome through its Command Line
Interface (CLI), accessible via a Telnet session.
Proceed as follows:
1. Start the Web browser on your PC.
2. Contact the STHome by entering one of the following:
The STHome IP address (default 10.0.0.138)
The STHome DNS hostname (default SpeedTouch.lan).
3. In case the STHome is protected by a System Password an
authentication window will pop up.
Enter the system password in the 'Password' field.
4. As a result the 'Welcome to the World of DSL' page pops up: