Troubleshooting guide

3 — NE user and device security
3-32 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
vii Choose one of the following from the IP Operator drop-down menu and enter
the range, if required:
• EQUAL
• RANGE
viii Save and close the form.
5 Save and close the form.
6 Choose the newly created NE CPM Firewall policy and click Properties.
7 The NE CPM Firewall form opens. The Configuration Mode parameter in the Policy
Configuration panel is in the Draft state. Release the policy and distribute the
policy as required.
i Click Switch Mode. A confirmation dialog box opens.
ii Click Yes to confirm the action. The Configuration Mode is changed to
Released state.
8 When you release the global policy, the policy is also distributed to local
definitions. See “To distribute a policy” in the 5620 SAM User Guide for
information.
Procedure 3-19 To delete a security policy
1 Choose the appropriate policy from one of the following.
a The Administration→Security→option 5620 SAM main menu
b The Policies→AAA Policies→option 5620 SAM main menu
The appropriate form opens.
2 Set the filter criteria, if applicable.
3 Click Search. A policy list opens.
Note 1 — When you delete site management access filter policies in
which the Action parameter is set to deny, ensure that you modify the
policy to set the parameter to permit before it is deleted, otherwise,
the 5620 SAM may be isolated.
Note 2 — You cannot remove a site management access filter if the
filter administrative state is up and the default action of the filter is set
to deny or deny host unreachable.
Note 3 — If you attempt to delete an OmniSwitch RADIUS or TACACS+
security policy that is applied to an authentication service, the
5620 SAM generates a deployment error. You must use the OmniSwitch
CLI to delete the policy from the authentication service before you can
delete the policy from the 5620 SAM.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01