Troubleshooting guide

3 — NE user and device security
Alcatel-Lucent 5620 Service Aware Manager 3-31
5620 SAM
System Administrator Guide
6 Select the newly created NE Management Access Firewall policy and click
Properties.
7 The Management Access Firewall form opens. The Configuration Mode parameter
in the Policy Configuration panel is in the Draft state. Release the policy and
distribute the policy as required.
i Click Switch Mode. A confirmation dialog box opens.
ii Click Yes to confirm the action. The Configuration Mode is changed to
Released state.
8 When you release the global policy, the policy is also distributed to local
definitions. See “To distribute a policy” in the 5620 SAM User Guide for
information.
Procedure 3-18 To configure an NE CPM firewall on the 7705 SAR-H
Perform the following procedure to configure a firewall using the CPM interface.
1 Choose Administration→Security→NE Firewall→NE CPM Firewall from the
5620 SAM main menu. The NE CPM Firewall form opens.
2 Perform one of the following:
a To create a firewall, click Create. The NE CPM Firewall (Create) form opens.
b To modify a firewall, click on search to display a list of firewall entries.
Choose an entry from the filtered list and click Properties. The NE CPM
Firewall (Edit) form opens.
3 Configure the required parameters.
4 Create one or more firewall entries.
i Click on the Firewall Entries tab.
ii Click Create. The Firewall Entry (Create) form opens.
iii Configure the required parameters.
iv Click Select, the Select Zone form opens.
v Choose a zone from the list and click OK.
vi Select the IP Operator check box from the IP Address panel on the Firewall
Entry (Create) form.
Note — The NE CPM firewall function is supported only on a Release 5.0
or later 7705 SAR-H.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01