Troubleshooting guide

3 — NE user and device security
3-18 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
5 When an SNMPv3 user account and group exist on a managed device, you can
configure the user authentication parameters. To configure the parameters,
perform the following steps.
i Click on the SNMPv3 tab.
ii Configure the required parameters.
6 To specify an RSA key for use by SFTP on a 7750 MG, perform the following steps.
i Click on the RSA Key tab.
ii Click Create. The RSA Key (Create) form opens.
iii Configure the parameters.
iv Save your changes and close the form.
7 Click Apply to save the changes.
8 Distribute the account to NEs, as required.
9 Close the open forms.
Procedure 3-8 To configure a password policy
Perform this procedure to create a policy that specifies the rules to which a password
must conform on one or more devices.
1 Choose Administration→Security→NE Password Policy from the 5620 SAM main
menu. The NE Password Policy form opens.
2 Click Create or choose an entry and click Properties. The Site Password Policy
(Create|Edit) form opens.
3 Configure the required parameters.
Note — If MD5 or SHA authentication and DES privacy is used, ensure
that the keys are on the device and associated with the SNMPv3 user
group.
Note — Only the 7750 MG supports RSA key configuration.
Note — To perform this procedure, you require an account with an
assigned administrator scope of command role to the sitesec package,
or a scope of command role with write access permission to the sitesec
package.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01