Troubleshooting guide

14 — As required maintenance tasks
14-30 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
vii Configure the required parameters in each successive panel until the
Database Restore panel is displayed. Use the values recorded during the most
recent 5620 SAM database installation or upgrade, and click Next in each
panel to continue.
viii Click Start Process. The restore process begins.
ix When the Installation Complete panel is displayed, open a separate console
window and run the script specified in the panel.
x When the script execution is complete, click Done to close the installation
utility. The database begins to initialize.
23 Perform the following steps to enable the 5620 SAM main server startup daemon.
i Log in to the main server station as the root user.
ii Open a console window.
iii Enter the following:
# cd /etc/init.d ↵
iv Enter the following:
# mv inactive.5620SAMServerWrapper 5620SAMServerWrapper ↵
24 Perform the following steps to start the 5620 SAM main server.
i Log in to the main server station as the samadmin user.
ii Enter the following to navigate to the server binary directory:
bash$ cd path/nms/bin ↵
where path is the 5620 SAM server installation location, typically /opt/5620sam/server
iii Enter the following to start the 5620 SAM server software:
bash$ ./nmsserver.bash start ↵
25 Close the open console windows on each station.
26 When the database restore is complete, perform a full resynchronization of the
network to discover the managed NE configuration changes and new devices.
Note — A 5620 SAM database restore takes considerable time,
depending on the database size.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01