Troubleshooting guide

14 — As required maintenance tasks
Alcatel-Lucent 5620 Service Aware Manager 14-3
5620 SAM
System Administrator Guide
3 Enter the following to run the Oracle SGA reconfiguration script:
# /opt/5620sam/db_name/install/config/db_name/SGA_reconfig.sh ↵
where db_name is the name of the 5620 SAM database, typically samdb
4 When the script execution is complete, enter the following to reboot the database
station:
# init 6 ↵
The database station reboots.
Procedure 14-2 To reconfigure a 5620 SAM main server after a RAM
upgrade
Perform this procedure to adjust the main server configuration after a RAM upgrade on
the main server station.
1 Log in as the samadmin user on the main server station.
2 Open a console window.
3 Perform the following steps to stop the main server, if it is running:
i Enter the following to navigate to the server binary directory:
bash$ cd path/nms/bin ↵
where path is the main server installation location, typically /opt/5620sam/server
ii Enter the following to stop the main server application:
bash$ ./nmsserver.bash force_stop ↵
iii Enter the following to display the main server status:
bash$ ./nmsserver.bash appserver_status ↵
The command displays a status message.
iv The main server is stopped when the command displays the following status
message:
Application Server is stopped
If the command displays another message, repeat step 3 iii. Do not proceed
to the next step until the server is stopped.
Note — You require root and samadmin user privileges on the main
server station to perform this procedure.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01