Troubleshooting guide

8 — NE maintenance
8-22 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
Procedure 8-10 To certify or synchronize OmniSwitch software
1 Choose Administration→NE Maintenance→OMNI Software Maintenance from the
5620 SAM main menu. The OMNI Software Maintenance form opens.
2 Perform one of the following:
a Select one or more NEs from the list and click Certify. Go to step 5.
b Select one or more NEs from the list and click Certify and Synchronize. Go to
step 5.
c Select one or more NEs from the list and click Flash Synchronization. Go to
step 5.
d Select one or mode NEs from the list and click Properties. The Software
Control Module (Edit) form opens.
3 Configure the Command to Apply parameter.
4 If the Command to Apply parameter was set to Reload, configure the Delayed
Activation Timer parameter.
5 Save your changes and close the forms.
Procedure 8-11 To configure an NE configuration rollback file
storage location
Perform this procedure to configure the storage location for the NE configuration
rollback rescue file or checkpoint files. To configure NE configuration rollback file
storage locations, FTP must be configured on the device; see the 5620 SAM User Guide
for more information.
1 Choose Administration→NE Maintenance→NE Configuration Rollback from the
5620 SAM main menu. The NE Configuration Rollback form opens.
2 Click on the NE Rollback tab. The NE Rollback list form opens.
3 Choose a device and click Properties. The NE Rollback (Edit) form opens.
4 To configure the storage location for the NE configuration rollback rescue file:
i In the Rescue File panel, configure the Rescue File Location Type parameter.
• If you specified FTP, in the Rescue File — Remote Location panel,
configure the required parameters.
• If you specified CFLASH, in the Rescue File — CFLASH panel, configure the
required parameters.
ii Save your changes.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01