Troubleshooting guide

7 — 5620 SAM system redundancy
Alcatel-Lucent 5620 Service Aware Manager 7-25
5620 SAM
System Administrator Guide
3 Enter the following to switch to the root user:
bash$ su - ↵
4 Navigate to the directory that contains the 5620 SAM installation software.
5 Perform one of the following.
a On a RHEL station:
i Enter the following:
# cd Linux ↵
ii Enter the following:
# ./ServerInstall_RHEL_R_r_revision.bin ↵
where
R_r is the release identifier, in the form MAJOR_minor
revision is the revision identifier, such as R1, R3, or another descriptor
b On a Solaris station:
i Enter the following:
# cd Solarisx86 ↵
ii Enter the following:
# ./ServerInstall_SolarisX86_SAM_R_r_revision.bin ↵
where
R_r is the release identifier, in the form MAJOR_minor
revision is the revision identifier, such as R1, R3, or another descriptor
The 5620 SAM server configuration utility opens and displays the Introduction
panel.
6 Click Next.
7 Accept the terms of the license agreement in the “Software License Agreement”
panel, and click Next.
8 Choose Main Server Configuration in the “Choose Installation Type” panel, and
click Next.
9 Click Next in each subsequent panel until the “Database Alignment” panel is
displayed.
10 Configure the “Enable Database Alignment” parameter.
11 If you selected the “Enable Database Alignment” parameter in step 10, select a
server to act as the preferred server.
Note — You must configure this parameter the same way on the
standby and primary main servers.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01