Troubleshooting guide

5 — 5620 SAM component configuration
Alcatel-Lucent 5620 Service Aware Manager 5-35
5620 SAM
System Administrator Guide
To enable a restriction in the distribution mode for certain types of local
policies that will permit local editing only. Additionally, the following
applies to this system preference configuration:
• Policy types supported by this system preference include Access
Ingress, Access Egress, Network QoS, ACL MAC, ACL IPv4, and ACL
IPv6.
• When creating any of these policies, if you set the Scope parameter
to exclusive, the 5620 SAM will set the distribution mode to local
edit.
• The 5620 SAM will not allow policies with the Scope parameter set
to exclusive to be assigned or used more than once.
• If you attempt to set the Policy Distribution Mode to Sync With
Global while the Scope attribute is configured as exclusive, an error
message will be displayed.
5620 SAM User Guide
To enable a policy change made using CLI to switch the distribution
mode for certain types of local policies to Local Edit Only, as opposed
to the default Sync with Global mode.
5620 SAM User Guide
5620 SAM Parameter
Guide
To allow for the automatic distribution of a global policy to applicable
NEs once the policy is released.
5620 SAM User Guide
To configure the maximum number of scheduled audit results stored for
a local policy.
5620 SAM User Guide
To enable all zones resynchronized from the node as local edit only. If
you disable the Discover Security Zone in Local Edit Only parameter, all
zones resynchronized from the node are set to Sync With Global.
• The Discover Security Zone in Local Edit Only parameter is only
supported on the 7705 SAR-8 with CSMv2, 7705 SAR-8v2 with CSMv2,
7705 SAR-18, 7705 SAR-H, 7705 SAR-Hc, and 7705 SAR-Wx variants,
Release 6.1 R1 or later.
5620 SAM User Guide
ESM tab
To configure system preferences associated with on-demand retrieval of
residential subscriber-related information from NEs.
5620 SAM User Guide
Custom NE Properties tab
To configure custom property labels and values on an NE, for example,
the location and site name that differs from the actual NE site name.
These properties cannot be configured on the NE. Additionally, the
following applies to this system preference configuration:
• If custom property labels are not configured, the default labels are
used.
• NE custom properties support the extended character set including
multi-byte characters.
• Custom property labels and values are displayed in the following
locations:
• NE Properties form
• NE List form
—
Function or setting Additionally see
(3 of 4)
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01