Troubleshooting guide

5 — 5620 SAM component configuration
5-20 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
4 Perform one of the following.
a On a RHEL station:
i Enter the following:
# cd Linux ↵
ii Enter the following:
# ./ServerInstall_RHEL_R_r_revision.bin ↵
where
R_r is the release identifier, in the form MAJOR_minor
revision is the revision identifier, such as R1, R3, or another descriptor
b On a Solaris station:
i Enter the following:
# cd Solarisx86 ↵
ii Enter the following:
# ./ServerInstall_SolarisX86_SAM_R_r_revision.bin ↵
where
R_r is the release identifier, in the form MAJOR_minor
revision is the revision identifier, such as R1, R3, or another descriptor
The 5620 SAM server configuration utility opens, and displays the Introduction
panel.
5 Click Next and accept the terms of the license agreement in the Software License
Agreement panel.
6 Click Next and choose Main Server Configuration in the Choose Installation Type
panel.
7 Click Next in each subsequent panel until the Standby Database Configuration
panel is displayed.
8 Select the Enable Database Backup File Synchronization parameter.
9 Click Next in each subsequent panel until the Installation Complete panel is
displayed.
10 Click Done to close the server configuration utility.
11 Enter the following to switch to the samadmin user:
# su - samadmin ↵
12 Navigate to the 5620 SAM server binary directory, typically
/opt/5620sam/server/nms/bin.
13 Enter the following:
bash$ ./nmsserver.bash read_config ↵
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01