Troubleshooting guide

4 — TCP enhanced authentication
4-6 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
4 To distribute a key chain:
i Select one or more key chains and click Distribute. The Distribute - KeyChain
form opens.
ii Select the required NEs by moving the appropriate row entries from the
Available Objects panel to the Selected Objects panel.
iii Click Distribute. The 5620 SAM distributes the key chains to the NEs.
iv Close the Distribute - KeyChain form. The TCP KeyChains form reappears.
5 To configure the distribution mode of a local definition:
i Click Switch Distribution Mode. The Switch Distribution Mode form opens.
ii Choose Sync With Global, Local Edit Only, or All from the drop-down menu.
Only the sites that are configured with the selected distribution mode are
listed.
iii Choose one or more entries in the Available Local Policies panel and click on
the right arrow. The chosen entries move to the Selected Local Policies
panel.
iv Depending on the current distribution mode of the chosen entries, perform
one of the following:
• Click Sync With Global.
• Click Local Edit Only.
The distribution mode of the selected entries changes accordingly.
v Close the Distribution Mode form.
6 Close the TCP KeyChains form.
Procedure 4-3 To verify the distribution of a global key chain to NEs
Perform the following procedure to view a list of the NEs to which the 5620 SAM has
successfully distributed a specific TCP key chain.
1 Choose Administration→Security→TCP KeyChains from the 5620 SAM main menu.
The TCP KeyChains form opens.
2 Select a key chain and click Properties. The KeyChain (Edit) form opens.
Note — Local definitions of key chains that use the Local Edit Only
distribution mode do not allow their NEs to receive the distribution of a
global key chain. You must set the distribution mode of a local key chain
to Sync With Global if you need the associated NE to receive the
distribution of a global key chain.
Release 12.0 R6 | November 2014 | 3HE 08861 AAAF TQZZA Edition 01