User guide

September 2009
Page 76 of 79 OmniSwitch 6400/6850/6855/9000/9000E—Release 6.4.2.R01
functionality.
140152 When the Auth-Server-Down policy is UNP and then block and
the VLAN in the UNP is configured as "authentication"
enabled, the show 802.1x non-supplicant command will display
"In progress" in the MAC-Authent Status column where in
reality the MAC is already been classified correctly to be in the
blocked/filtering state.
There is no known workaround at
this time. This is a display issue
only.
Captive Portal
PR Description Workaround
126064 The customized Captive Portal backgroud image is
sometimes not loaded in the status page when IE 6 is used.
Use IE 7 with Captive Portal.
131029 After authentication the Captive Portal login page can be
accessed by entering the Captive Portal login URL.
There is no known workaround at
this time.
System
General
PR Description Workaround
131936 If 2 exit commands are entered at the same time from 2
different telnet sessions then one of the sessions may not be
closed
Simply enter exit again if the
session fails to close
138342 The Daylight Saving Time on an OS6400 may get set incorrectly
when using the 'system daylight savings time' command.
There is no known workaround
at this time.
130275 Rebooting a switch from a telnet session does not close the
client session.
There is no known workaround at
this time.
122901 Trap and swlog notifications are generated when hash collision
happens in L2_Entry table and MAC_VLAN table in Switching
ASIC.
There is no known workaround at
this time.
137961 Flow control not functioning with E2E flow control enabled
when packet size > 512 bytes.
There is no known workaround at
this time.
124844 In stack environment, egress port-mirroring of layer3 packets
fails when packets are originated from software with SRC MAC
as router MAC and are destined to another unit in a stacked
configuration.
There is no known workaround at
this time.
NI/Hardware
PR Description Workaround
105646 entPhysicalModelName MIB variable returns vendor name of
SFP instead of model name.
There is no known workaround at
this time.
112489 Jumbo frame size configuration is not saved in boot.cfg for
combo ports running at 100mbps.
There is no known workaround
at this time.
122798 Jabber frame counters do not get updated in the "show
interfaces accounting" command.
There is no known workaround
at this time.