User guide

September 2009
Page 74 of 79 OmniSwitch 6400/6850/6855/9000/9000E—Release 6.4.2.R01
this time.
132424 With STP switchover disabled, multicast traffic flow does
not begin until the next periodic PIM Join message when a
receiver rejoins the multicast group.
There is no known workaround at
this time.
139807 If the priority option is used with the 'ipv6 pim candidate-rp'
cli command, this will not be saved in the boot.cfg.
There is no known workaround at
this time.
UDP
PR Description Workaround
138486 Only 23 generic UDP services are supported. There is no known workaround
at this time.
139972 When configuring Generic UDP Relay Service over various
VRF, if different set of UDP ports are used across VRFs, the
UDP traffic on some of the UDP ports will get dropped.
Use the same set of UDP Ports
across VRFs.
MPLS
PR Description Workaround
124844 On stack environment, egress port-mirroring of layer3 packets
fails when packets are originated from software with SRC
MAC as router MAC and are destined to another unit in a
stacked configuration.
There is no known workaround
at this time.
134749 Configuring an LDP interface on an IP interface associated to
a VLAN that contains physical ports belonging to different
MPLS routers is not supported.
Configure two different IP
interfaces and using these IP
interfaces to create two distinct
LDP interfaces.
134751 The help for the 'configure oam' CLI command displays
unsupported parameters.
There is no known workaround
at this time.
135696 LDP is only supported on the System IP interface and its
address (i.e Loopback0 interface IP address) in this release.
LDP sessions cannot be setup on non-System IP address
interfaces in 6.4.2.R01 release.
There is no known workaround
at this time. The Transport-
Address LDP feature is
currently not supported.
135929 The Omniswitch only support TPID values of 8100. There is no known workaround
at this time.
138011 With static LSP configured, local Vlan disable or IP Interface
disable scenario will drop incoming traffic instead of
switching it to the protecting Next-hop for the duration of the
ARP Aging timer.
The ARP Aging Timer (Mac-
Address Table Aging Timer)
can be set to the minimum
value of 60 sec so that aging
occurs in 60 to 180 sec for the
ARP entry.
138018 After takeover the 'show service sdp detail' does not show any
LSPs in the Programmed LSP list.
There is no known workaround
at this time.