User guide

September 2009
OmniSwitch 6400/6850/6855/9000/9000E------ Release 6.4.2.R01 Page 73 of 79
LAYER 3
General
PR Description Workaround
139233 When using route maps to aggregate all the learned routes
into a default route, the router still advertises the default route
even if all the routes are inactive.
There is no known workaround at
this time.
138549 It is possible to create a static route where the gateway is an
exact match of a local interface address.
Configure static routes with a
gateway that is an actual nexthop in
the network.
BFD
PR Description Workaround
130089 Getnext operation returns wrong data type for the following
MIB objects: alaBfdGlobalTxInterval
alaBfdGlobalRxInterval alaBfdGlobalVersionNumber
There is no known workaround at
this time.
136103 The 'ip ospf bfd-std all-interfaces' command will set any
currently disabled interfaces back to enable.
There is no known workaround at
this time.
138748 BFD session table in the neighbor switch changes after
takeover.
There is no known workaround at
this time.
GVRP
PR Description Workaround
139875 A GVRP enabled port my be stuck in blocking after deleting
or creating MST regions.
There is no known workaround at
this time.
IP/IPv6
PR Description Workaround
137810 Packets greater than 1600 bytes are not routed into
IPV6/IPV4 tunnel.
There is no known workaround at
this time.
130309 IPv6 communication is dropped when dhcp snooping ip
source filter is enabled.
There is no known workaround at
this time.
131227 The ordering of rules in a security policy is not being
checked in inbound traffic. As long as an incoming packet
has the IPsec headers required, it will not be dropped even if
they are in a different order than the rules specify.
There is no known workaround at
this time.
PIM-SM/PIM-SMv6
PR Description Workaround
128372 PIM-SMv6 drops multicast packets greater than 1500 bytes. There is no known workaround at