User guide

September 2009
OmniSwitch 6400/6850/6855/9000/9000E------ Release 6.4.2.R01 Page 71 of 79
Ports > Port Association "Move ports" button fails to move
more than 128 ports into a VLAN.
116535 Webview supports maniputing only 64 items at a time in a
table with more than 64 entries.
Select items to be modified in
groups of 64.
117581 WebView System > System Mgmt > Install "File Selection"
browse and select files locks IE7 on Windows Vista.
Use the Firefox browser with
Windows Vista.
119679 WebView System management->File management->local
backup creates mutiple files.
There is no known workaround at
this time.
129131 Cannot enable more than 54 traps at a time through
WebView.
When using WebView to configure
traps, configure less than 54 traps
at a time.
LAYER 2
General
PR Description Workaround
139663 NI CPU may go above threshold (currently 80%) if
configuring a large number of VLANs (greater than approx.
200) and IP subnet rules in a short amount of time (less than
10 seconds) between commands. However, there is no
impact on operational status.
There is no known workaround at
this time.
ERP
PR Description Workaround
139869 ERP port state on link up of ETHOAM configured link may
sometimes display incorrectly.
There is no known workaround at
this time. This is a display issue
only.
139870 ERP port state on link up of ETHOAM configured link may
sometimes display incorrectly.
There is no known workaround at
this time. This is a display issue
only.
139974 While reloading a node in an erp ring the "show erp port"
command may display RPL node port is blocking while the
'show erp' command indicates protection mode (idle).
Disable the ERP-ring & enable it
again on the node.
Ethernet OAM
PR Description Workaround
138474 Ethernet OAM loopback packets for a linkagg port where the
member ports span multiple NI's, will not be mirrored.
There is no known workaround at
this time.