User guide

September 2009
Page 70 of 79 OmniSwitch 6400/6850/6855/9000/9000E—Release 6.4.2.R01
Open Problem Reports and Feature Exceptions
The problems listed here include problems known at the time of the product’s release. Any problems
not discussed in this section should be brought to the attention of the Alcatel-Lucent Technical
Support organization as soon as possible. Please contact customer support for updates on problem
reports (PRs) where no known workaround was available at the time of release.
SWITCH MANAGEMENT
CLI
PR Description Workaround
113928 After a MAC movement due to a new mobility rule match
the entry may still be displayed with the previous
information.
There is no known workaround at
this time. This is a display issue
only.
120389 When there is no policy server defined the "show policy
server statistics" returns the following incorrect error
message: "No policy statss"
There is no known workaround at
this time.
130840 BOOTP UDP relay service is not configurable for
destination VLAN using the 'ip udp relay' command.
Use the 'ip helper' command.
131550 The CLI command 'show mac-address-table quarantined' will
display "UNP" and "HIC" MAC addresses as well.
There is no known workaround at
this time.
SNMP
PR Description Workaround
139563 Unable to create policy rule group thorugh SNMP. Create the policy list using CLI,
WebView or OmniVista and LDAP
along with the AAA configuration.
139984 SNMP2 mibwalk fails at .1.3.6.1.2.1.17.7.1.4.5.1.4
(dot1qPortVlanTable) if the last two ports of the
system are mobile ports.
Disable mobility on the last two ports
to complete the MIB walk.
Web Management
Feature Exceptions
WebView uses signed applets for the automatic IP reconfiguration. Those applets are signed using VeriSign
Certificates that expire every year. The certificate used for Internet Explorer and Netscape expires every August.
WebView users have to validate a warning indicating that the certificate used by the applet has expired.
PR Description Workaround
116091 WebView Layer 2 > VLAN Mgmt > VLAN Configuration > Move 128 ports at a time.