User guide

September 2009
OmniSwitch 6400/6850/6855/9000/9000E------ Release 6.4.2.R01 Page 5 of 79
System Requirements
Memory Requirements
• OmniSwitch 6400 Series Release 6.4.2.R01 requires 256 MB of SDRAM and 128MB flash
memory. This is the standard configuration shipped.
• OmniSwitch 6850 Series Release 6.4.2.R01 requires 256 MB of SDRAM and 64MB of flash
memory. This is the standard configuration shipped.
• OmniSwitch 6855 Series Release 6.4.2.R01 requires 256 MB of SDRAM and 128MB flash
memory. This is the standard configuration shipped.
• OmniSwitch 9000 Series Release 6.4.2.R01 requires 256 MB of SDRAM and 128MB of flash
memory for the Chassis Management Module (CMM). This is the standard configuration
shipped.
• OmniSwitch 9000E Series Release 6.4.2.R01 requires 1GB of SDRAM and 256MB of flash
memory for the Chassis Management Module (CMM). This is the standard configuration
shipped.
Configuration files and the compressed software images—including web management software
(WebView) images—are stored in the flash memory. Use the show hardware info command to deterine
your SDRAM and flash memory.
UBoot, FPGA, Miniboot, BootROM, Upgrade Requirements
The software versions listed below are the minimum required, except where otherwise noted. Switches
running the minimum versions, as listed below, do not require any Uboot, Miniboot, or FPGA
uprades when upgrading to AOS 6.4.2.R01.
Switches not running the minimum version required should upgrade to the latest Uboot, Miniboot,
FPGA that is available with the 6.4.2.R01 AOS software available from Service & Support.
OmniSwitch 9000
Release Miniboot.uboot CMM UBoot CMM UBoot NI FPGA CMM
6.4.2.R01 6.3.4.265.R01 6.3.4.265.R01 6.3.4.265.R01 Major Revision: 2
Minor Revision: 25
(displays as 0x19;
recommended)
OmniSwitch 9000E
Release Miniboot.uboot CMM UBoot CMM UBoot NI FPGA CMM
6.4.2.R01 6.4.1.149.R01 6.4.1.149.R01 6.4.1.149.R01 Major Revision: 2
Minor Revision: 25
(displays as 0x19;
recommended)