User guide

OmniSwitch 6850-24X OmniSwitch 6850 Series Chassis and Hardware Components
page 2-32 OmniSwitch 6850 Series Hardware Users Guide April 2010
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-54. For information on the chassis rear panel, refer to page 2-56.
OmniSwitch 6850-24X Front Panel
Console Port
The OS6850-24X front panel
provides one RJ-45 port for con-
sole connections. Console con-
nections are used by network
administrators for switch man-
agement. This female RJ-45 con-
nector provides a DTE console
connection.
Status and Slot Indicator LEDs
For information on the OS6850-24X’s
status and slot indicator LEDs, refer to
page 2-54.
USB Port
High speed USB 2.0 port,
which can be used for quick
upgrades.
Combo SFP
The OS6850-24X provides four combo
SFP connectors for 1000Base-X high-
speed connections
.
By default, when an SFP is installed in a
combo port, it takes over the port number
of the corresponding RJ-45 Ethernet port.
In other words, if an SFP is installed in
the slot labeled 24, Ethernet port 24
would no longer be available and cannot
be used for 10/100/1000 traffic. This
default setting is referred to as “preferred
fiber.” Refer to “Configuring Ethernet” in
the Network Configuration Guide for
detailed information, including steps for
configuring combo port settings
.
XFP
The OS6850-24X front panel provides
two for 10 Gbps Small Form Factor
Pluggable (XFP) transceivers.
OmniSwitch 6850-24X
USB
Console
OK
PRI PWR BPS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
25
26
26
25
CLASS 1 LASER PRODUCT
CLASS 1 LASER PRODUCT
21 22 23 24
10/100/1000Mbps
The OS6850-24X provides 20 fixed 10/100/1000BaseT
non-combo (1–20) and 4 fixed
10/100/1000BaseT combo (21–24). These are auto-
sensing and auto-MDIX and use RJ-45 connectors.