User guide

Creating Policies Configuring QoS
page 23-32 OmniSwitch 6600 Family Network Configuration Guide April 2005
To display only policy rules that are active (enabled and applied) on the switch, use the show active policy
rule command. For example:
-> show active policy rule
Policy From Prec Enab Inact Refl Log Save Matches
mac1 cli 0 Yes No No No Yes 0
Cnd/Act: dmac1 -> pri2
In this example, the rule my_rule does not display because it is inactive. Rules are inactive if they are
administratively disabled through the policy rule command, or if the rule cannot be enforced by the
current hardware. Although my_rule5 is administratively active, it is still pending and not yet applied to
the configuration. Only mac1 is displayed here because it is active on the switch.
See the OmniSwitch CLI Reference Guide for more information about the output of these commands.