User guide

Using Interswitch Protocols Configuring GMAP
OmniSwitch 6600 Family Network Configuration Guide April 2005 page 9-11
Configuring the GMAP Hold Time
The GMAP hold time specifies the length of time the switch retains information received in GMAP update
packets. By default, the holdtime interval is 4320 minutes (72 hours).
To display the current holdtime interval, enter the following command:
-> show gmap
To change the holdtime interval, use either of these forms of the command with the desired value (any
value between 1 and 65535). Note that use of the time command keyword is optional. For example:
-> gmap hold 500
-> gmap hold time 250
Displaying GMAP Statistics
Use the show gmap command to view statistics for all MAC addresses.
-> show gmap
GMAP is currently enabled,
GMAP Holdtime Interval (minutes) = 4320,
GMAP Updatetime Interval (seconds) = 300,
GMAP Gaptime Interval (milliseconds) = 133
MAC Address Protocol VLAN Src Switch ID Timeout(sec)
--------------+---------+------+--------------+------------
000502:c07f11 1809B 12 0020da:ecc770 3536
800 12 0020da:ecc770 3536
00105a:1873b9 1809B 12 0020da:ecc770 3536
800 12 0020da:ecc770 3536
See the OmniSwitch CLI Reference Guide for information about the show gmap command.