User guide

Open Problem Reports and Feature Exceptions
page 86 OmniSwitch 6600/7000/8800—Release 5.1.5.R04
PR 81620
After LDAP server is deleted from a switch, there is no way to remove all related policies from QoS layer.
Workaround: Remove QoS policies before deleting LDAP server.
PR 82571
When entering more than one LDAP policy server, they are retrieved/set incorrectly through SNMP.
Workaround: Enter the policy servers through the CLI.
PR 84257
If there is traffic going out to ipport A via slot/port B on an OS6600 and there are two rules, rule one spec-
ifying destination ippport A and rule B specifying destination slot/port B, then rule one is not effected on
the traffic.
Workaround: Try defining the rules without specifying the destination slot/port.
PR 84386
In some setups where the same destination is used but the source is different, a Layer 4 rule will not affect
traffic if another rule of higher precedence exists on an OS6600.
Workaround: Make the Layer 4 rule the highest precedence rule.
PR 84425
Drop rule still enforced when source MAC or source VLAN is changed in a secure switch access condi-
tion on an OS6600.
Workaround: There is no known workaround at this time.
PR 87417
On the OS7000, the user can modify the built-in port groups. But, modifications may not be saved to the
config, and the switch will boot-up with the default built-in port groups.
Workaround: Do not modify the built-in port groups.
.