User guide

Open Problem Reports and Feature Exceptions
OmniSwitch 6600/7000/8800—Release 5.1.5.R04 page 69
PR 70811
A default VLAN might come up in operational state when it is disabled to accommodate group mobility.
Workaround: There is no known workaround at this time.
PR 70954
The first IPX encapsulation learned on a fresh OS6624/6648 switch becomes the only encapsulation that
can be learned until the switch is rebooted regardless of the encapsulation selected in the IPX (ipx-e2, ipx-
llc, or ipx-novell) protocol rule.
Workaround: There is no known workaround at this time.
PR 71665
Setting the egress flood limit to zero will still allow a small number of flood packets to egress the port.
Workaround: There is no known workaround at this time.
PR 72223
ENI 10/100C-24 Autoneg disabled if speed/duplex changed to non-auto.
Workaround: There is no known workaround at this time.
PR 73334
When the configuration for a range is applied on the OmniSwitch 8800, and if there is an error in the
middle of the group configuration (all slot, groups of ports), the rest of configuration will not apply from
the point of error.
Workaround: Apply the configuration from the next valid starting point (e.g. next valid port).
PR 73367
Mobile and default VLAN traffic flow is not effective if the ingress frames to the OS6600 series switches
contain IEEE 802.1Q VLAN tagging and mobile-tagging is disabled for the destination VLAN; transpar-
ent tagging is not supported.
Workaround: There is no known workaround at this time.
PR 75199
When using group mobility custom rule, traffic will go on the default VLAN even though the content (at
the offset) of a new stream of traffic (from the same MAC device) is matching the MAC address already
learned in the default VLAN.
Workaround: Flush the MAC address learned on the default VLAN, then resending traffic.