User guide

Open Problem Reports and Feature Exceptions
OmniSwitch 6600/7000/8800—Release 5.1.5.R04 page 61
Source Learning
Feature Exceptions
The number of MAC addresses supported on an OS6600 is 8K.
Problem Reports
PR 53663
MAC load balancing does not spread out the MACs among 4 ports on the OS7000.
Workaround: There is no known workaround at this time.
PR 54930
The CLI command show mac-address-table count does not have an equivalent in SNMP or WebView on
the OS7000.
Workaround: There is no known workaround at this time.
PR 57013
Boot.cfg only changes the age-time value for VLAN1 on the OS7000 although its been configured for all
the VLANs.
Workaround: The user should specify the VLAN information while configuring aging time for MAC
address table in the boot.cfg, like: mac-address-table aging-time 1000000 VLAN 2.
PR 57976
All MACs age out when a cable is pulled and re-inserted after traffic is stopped during Source Learning on
the OS7000. Spanning Tree recalculates and flashes all MACs belonging to the same VLAN as the cable
is re-inserted.
Workaround: Make the port being unplugged an "edge port". Spanning tree will ignore the re-insertion
event and not flash out all MACs learned.
PR 59745
Due to the time required for the aging check, the aging-time is not very accurate for small measures of
time i.e. under 1 minute on the OS7000.
Workaround: There is no known workaround at this time.