User guide

Open Problem Reports and Feature Exceptions
page 58 OmniSwitch 6600/7000/8800—Release 5.1.5.R04
Problem Reports
PR 35206
The reQid packet delivery is unreliable if Qid has problems on the OS7000. It affects port mirroring. The
port mirroring feature may display frames that were received by the switch but never set out because the
queue was already full.
Workaround: There is no known workaround at this time.
PR 66806/66847
Packets are mirrored only if the hardware is programmed on an OS6624/6648. During the learning
process, the hardware is not yet programmed. Under heavy traffic not all packets will be mirrored.
Workaround: There is no known workaround at this time.
PR 66845
The mirroring (destination) port on the OS8800 gets one frame extra with 'Unknown SA and Known DA'
Egress traffic on Mirrored port
Workaround: Use second generation modules.
PR 66862
Port mirroring is not supported across the stack. Please note that you cannot do port mirroring between
upper and lower 24 ports on an OS6648.
Workaround: There is no known workaround at this time.
PR 68515
Performance of port mirroring is around 3000 packets/second after a hot swap on the OmniSwitch 8800.
Workaround: There is no known workaround at this time.
PR 69612
On the OS7000, the mirrorConfigError' trap parameters have incorrect data type COUNTER32 instead of
INTEGER.
Workaround: There is no known workaround at this time.
PR 69613
The mirrorUnlikeNi' trap parameters have incorrect data type COUNTER32 instead of INTEGER.
Workaround: There is no known workaround at this time.