User guide

Open Problem Reports and Feature Exceptions
page 54 OmniSwitch 6600/7000/8800—Release 5.1.5.R04
PR 75538
On the OS6600 series switches, not able to change dynamic Linkagg Parameters on run time.
Workaround: Delete the linkagg lacp port and add with new modified parameters.
PR 77684
On the OS7000, replacing second generation NIs with first generation NIs causes ports not to come up.
Workaround: If second generation boards are hotswapped with first generation boards, some linkagg
ports may not come up. Replace second generation interfaces with second generation interfaces only.
PR 77693
On the OS7000, Not able to pass traffic through a linkagg if the traffic is originated from the same slice as
linkagg.
Workaround: Do not use same NI port to pass the bridged traffic through the same slice ports configured
as linkagg.
PR 78281
If second generation NI ports come up first, cannot add first generation NI ports to the same aggregate.
Workaround: When configuring mixed NI version ports in the same agg, make sure first generation ports
added first before adding second generation ports.
PR 78374
After hotswapping a second generation NI with a first generation NI, spanning tree detects a misconfigura-
tion.
Workaround: Do not hot swap a second generation board with first generation board, if linkagg is config-
ured across multiple boards.
PR 78752
On the OS6600 series switches, deleting actor system id on lacp port makes the display set to all Zero.
Workaround: LACP port needs to set with a non Zero system id else, the default system id will be used.
Delete the port and add again to use the default system id.
PR 78804
On OS6600 series switches, changing LACP parameters on runtime affects the LACP mechanism.
Workaround: Don’t change LACP port parameters on run time. If modification needed, delete and add
the port again