User guide
Open Problem Reports and Feature Exceptions
page 50 OmniSwitch 6600/7000/8800—Release 5.1.5.R04
PR 80143
Windows IGMPv1 clients do not respond to IPMS queries on an OS7000.
Workaround: There is no known workaround at this time.
PR 81111
On the OS8800, IPMS routes packets through the 10Gig NI in software only, even to untagged ports.
Hardware forwarding is only available for bridged traffic over the 10Gig NI. As a result multicast routing
performance is greatly reduced.
Workaround: There is no known workaround at this time.
PR 83680
When a mirroring port is configured on an OS6600, IP multicast traffic may temporarily be disabled until
the various information is relearned on the mirroring and mirrored ports.
Workaround: There is no known workaround at this time.
PR 83721
When a 'proxy version' is configured to V3 on an OS7000, 'default' itself is changed to 'V3'. Hence CLI is
saying 'V3' when it says 'default' after 'proxy version' is configured to 'V3'. This can be verified by invok-
ing show ip multicast switching through CLI.
Workaround: There is no known workaround at this time.
PR 83765
IPMS does not perform IGMPv3 Include/Exclude filtering on a per VLAN basis on an OS7000.
Workaround: There is no known workaround at this time.
PR 83965
CLI and WebView do not allow configuration of "Last Member Query Interval" on an OS800.
Workaround: It can be configured through SNMP object igmpInterfaceLastMembQueryIntvl.
PR 83992
The igmpInterfaceStatus value can not be set through CLI or WebView on an OS7000.
Workaround: IGMP enable/disable is not supported per VLAN interface, though it is supported per
router. Though setting igmpInterfaceStatus through SNMP succeeds, the router's interface configuration
does not change.