Specifications

64 Hardware Basics March 2005
OmniSwitch 6600-P24 Front Panel
CONSOLE
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1
2
EXPANSION/STACKINGEXPANSION
25 26 27 28
TM
OmniSwitch 6600-P24
OK1
OK2
PS1
PS2
PRI
SEC
TEMP
FAN
SEL
LINK/ACT
LINK/ACT
LINK/ACT
LINK/ACT
10/100 PoE Ports
The OS6600-P24 provides 24 Power
over Ethernet (PoE) 10/100 Ethernet
ports. These ports are twisted-pair
and are individually configurable as
10BaseT or 100BaseTX. The ports
use RJ-45 connectors.
Console Port
The OS6600-P24 front panel provides one RJ-
45 port for console connections. Serial console
connections are used by network administrators
for switch management. This connector pro-
vides a DCE console connection.
Status and Slot Indicator LEDs
For information on the OS6600-P24’s sta-
tus and slot indicator LEDs, refer to page
67.
Stacking or Uplink Module Slot
The OS6600-P24 provides an additional slot that can
accommodate either a stacking module or a Gigabit
Ethernet uplink module.
If you use a Gigabit Ethernet uplink module in this slot,
the OS6600-P24 must be used as a stand-alone switch.
A stacking module must be installed in this slot if the
switch is to be used in a stacked configuration. For infor-
mation on stacking switches, refer to page 24.
Gigabit Ethernet Uplink Module Slot
The OS6600-P24 provides a dedicated slot for Gigabit Ethernet
uplink modules. This slot supports the following module types:
• OS6600-GNI-C2—Provides two fixed 1000BaseT copper
connections (uses two RJ-45 connectors). Supports distances
up to 100 meters.
• OS6600-GNI-U2—Provides two MiniGBIC bays that
support hot-swappable 1000BASE-X MiniGBIC transceiv-
ers.
Slot Selector Button
The slot selector button, located directly
beneath the slot indicator LED, is used to
manually assign slot numbers to switches
in stacked configurations. Refer to
“Assigning Slot Numbers” on page 25 for
detailed information.