Specifications

16 Setting Up the Hardware March 2005
5 Tighten the two captive screws, located at the left and
right sides of the power supply’s front panel. Be sure not
to overtighten the captive screws. If you use a screw-
driver, the torque used to tighten the screws must not
exceed 2.3 inch pounds.
6 On OS6624, OS6648, OS660-U24, and OS6600-P24
switches verify that the power supply’s on/off switch is in
the off ( O ) position.
7 Plug a power cord (supplied) into the unit’s power
socket; next, plug the cord into an easily-accessible,
grounded power source.
Note. Do not turn on the power supply at this time. You
will power on all supplies later in the setup process.
8 If you are installing back up power supplies in a multi-
chassis, stacked configuration, install all remaining power
supply units now by repeating steps 1 through 7 for each
chassis.
9 Continue to “Installing Uplink and Stacking Modules”
on page 16.
Installing Uplink and Stacking
Modules
OmniSwitch 6600 Family switches support the following
modules:
• OS6600-GNI-C2 Copper Gigabit Ethernet Uplink
Module
• OS6600-GNI-U2 Fiber Gigabit Ethernet Uplink
Module
• Stacking Module
Note. This section does not apply to OS6602-24 and
OS6602-48 switches.
MODEL NO:
OS
RATING:
100-24
0V
THIS DEVICE COMPLIES W
ITH
IS SUBJECT
TO THE FOLLOWIN
G
T
(1) THIS
DEVICE MAY
NOT CAUSE H
AR
(2) THIS
DEVICE MUST
ACCEPT
ANY INT
ER
INTERFERENCE THAT M
AY CAUSE UNDESI
RED
THIS CLASS
A D
IGITAL AP
PAR
ATUS MEETS
ALL
REQU
IRE
CANADIAN INTERFER
ENCE-CAUSING EQUIPMENT
REGU
LAT
CET APPAREIL NUMÉ
RIQUE DE LA CLA
SSE A
RESPECTE TOU
TS L
ES
EXIGENCES DU
REGLEMENT SUR LE MATÉRIEL BROUILLEUR DU CAN
ADA
Assembled in the US of US and Non-US Component
s
!
CAUTION:
THIS UNIT MA
Y
BE EQUIPPED
WITH TWO POWER CONNECTIONS.
T
O REDUCE
THE RISK OF
ELECTRICA
L SHOCK, DISCO
NNECT
BOTH POWER
CONNECTION
S BEFORE
SER
VICING UNIT.
ATTENTION:
CET APPAREIL
COMPOR
TE
PLUS D'UN CO
RDO
N D'ALIMENT
ATION. AFIN DE
PREVENIR LE
S CHOCS EL
ECTRIQUES,
DEBRANCHE
LES DEUX CO
RDO
NS D'ALIMENT
ATION AVAN TE DE
FAIRE LA
REP
ARATION.
50/60 Hz, 2/2/1 A
100/115/230
V