Specifications

12 Setting Up the Hardware March 2005

2 Attach the flanges to the chassis using the provided

Phillips-head screws. Be sure to tighten each of the screws

firmly using a Phillips screwdriver.

3 After the rack-mount flanges are secured to the chas-

sis, mark the holes on the rack where the switch is to be

installed.

4 Lift and position the switch until the rack-mount

flanges are flush with the rack post.

5 Align the holes in the flanges with the rack holes that

were marked in step 3.

6 Once the holes are aligned, insert a rack mount screw

(not provided) through the bottom hole of each flange.

Tighten both screws until they are secure.

Note. Be sure to install the screws in the bottom hole of

each flange, as shown, before proceeding.

7 Once the screws at the bottom of each flange are

secure, install the remaining two rack mount screws. Be

sure that all screws are securely tightened.

8 On OS6624, OS6648, OS660-U24, and OS6600-P24

switches verify that the on/off switch for the OmniSwitch

6600 Family switch is in the off ( O ) position. The on/off

switch is located on the switch’s rear panel.

OmniSwitch 662

PS1

PS2

SEC

FAN

CONSOLE

SEL

EXPANSION/ST

ACKING

EXPANSION

051