System information

Configuring the Switch
2-23
Configuring the Switch
The Device Control menu is used to control a broad range of functions, including
port configuration, Spanning Tree, port mirroring, multicast filtering, and Virtual
LANs. Each of the setup screens provided by these configuration menus are
described in the following sections.
Alcatel OmniStack 6124
< Switch Configuration Menu >
Port Configuration Extended Bridge Configuration
Port State 802.1P Configuration
Spanning Tree Configuration 802.1Q VLAN Base Information
Spanning Tree Information 802.1Q VLAN Current Table Information
Mirror Port Configuration 802.1Q VLAN Static Table Configuration
Port Trunking Configuration 802.1Q VLAN Port Configuration
IGMP Configuration Port GARP Configuration
BStorm Control Configuration Port GMRP Configuration
Port Security Configuration
<Ok>
Use <TAB> or arrow keys to move. <Enter> to select.
Menu Description
Port Configuration Sets communication parameters for ports.
Port State Displays current port settings and port status.
Spanning Tree Configuration Configures the switch and its ports to participate in a local Spanning Tree.
Spanning Tree Information Displays the current Spanning Tree configuration for the switch and its ports.
Mirror Port Configuration Sets the source and target ports for mirroring.
Port Trunking Configuration Specifies ports to group into aggregate trunks.
IGMP Configuration Configures IGMP multicast filtering.
BStorm Control Configuration Allows you to enable/disable broadcast storm control on a per-port basis and
set the packet-per-second threshold.
Port Security Configuration Allows you to enable and configure port security for the switch.
Extended Bridge Configuration Displays/configures extended bridge capabilities provided by this
switch.
802.1P Configuration Configures default port priorities and queue assignments.
802.1Q VLAN
Base Information
Displays basic VLAN information, such as VLAN version number and
maximum VLANs supported.
802.1Q VLAN Current Table
Information
Displays VLAN groups and port members.
802.1Q VLAN Static Table
Configuration
Configures VLAN groups via static assignments, including setting port
members.
802.1Q VLAN Port ConfigurationDisplays/configures port-specific VLAN settings, including PVID and ingress
filtering.
Port GARP Configuration* Configures generic attribute settings used in the spanning tree protocol,
VLAN registration, multicast filtering.
Port GMRP Configuration* Configures GMRP multicast filtering.
* Not implemented in this firmware release.