User guide

Managing Switch Configurations - Single CMM Managing CMM Directory Content
page 4-16 OmniSwitch AOS Release 7 Switch Management Guide March 2015
Show Currently Used Configuration
Depending on how a a switch is booted different directories can become the RUNNING DIRECTORY.
See “Where is the Switch Running From?” on page 4-4. for additional information.
To check the directory from where the switch is currently running, enter the following command:
-> show running-directory
CONFIGURATION STATUS
Running CMM : PRIMARY,
CMM Mode : DUAL CMMs,
Current CMM Slot : A,
Running configuration : WORKING,
Certify/Restore Status : CERTIFY NEEDED
SYNCHRONIZATION STATUS
Running Configuration : NOT AVAILABLE,
The command returns the directory the switch is currently running from and which CMM is currently
controlling the switch (primary or secondary). It also displays wheter the switch is synchronized.
Show Switch Files
The files currently installed on a switch can be viewed using the show microcode command. This
command displays the files currently in the specified directory.
To display files on a switch, enter the show microcode command with a directory, as shown:
-> show microcode certified
Package Release Size Description
-----------------+---------------+--------+-----------------------------------
Ros.img 7.1.1.311.R01 2486643 Alcatel-Lucent OS
Reni.img 7.1.1.311.R01 941331 Alcatel-Lucent NI
If no directory is specified, the files that have been loaded into the running configuration are shown.