User guide

Installing Software Licenses Managing System Files
page 3-16 OmniSwitch AOS Release 7 Switch Management Guide March 2015
Installing Software Licenses
Some features require a software license and are restricted only to a licensed user. Purchasing a license
part number along with an authorization code from Alcatel-Lucent is required. The authorization code is
then used to generate a license file.
To generate a license file, install the file on the switch, and active features, do the following:
1 Log on to https://service.esd.alcatel-lucent.com/portal/page/portal/EService/LicenseGeneration and
provide the serial number and MAC address of the switch along with the authorization code. Use the serial
number and CMM MAC address from the show chassis command.
A license file, for example swlicense.txt, is generated. A license file can have any name.
2 Save the swlicense.txt file in the /flash directory of the primary CMM.
3 To install the license onto the switch, use the license command with the file name and reboot the
switch. For example:
-> license apply file /flash/swlicense.txt
4 To verify the installation after reboot, use the show license-info command.
Note. For multiple entries of serial numbers, MAC addresses, and authorization codes, use a CSV format-
ted file and upload the file on to the website. A single license file is generated for all the switches.
Once the license is applied it is written to the EEPROM and the license file is no longer needed.
Licensed Feature Matrix
OmniSwitch 6900 OmniSwitch 10K
Advanced DataCenter Advanced DataCenter U16L
OSPF v2/v3 VRRP DCB (PFC,
ETS, DCBx)
SPB DCB (PFC,
ETS, DCBx)
OS10K-XNI-
U16
BGP VRRP v3 EVB Virtual Chassis EVB
MP-BGP ECMP for
OSPF
FIP Snooping FIP Snooping
Policy Based
Routing
RIPng
DVMRP PIM-SM/DM
PIM-SM IPv6 IPSec
VRF SPB
Virtual Chassis