User guide

SNMP Traps Table
OmniSwitch AOS Release 7 Switch Management Guide March 2015 page B-41
alaDhcpSrvLeaseThresholdStatus—The threshold status of subnet utilization.
alaDhcpSrvSubnetDescriptor—The subnet descriptor. If the subnet belongs to a shared network, this object
specifies the shared network name; otherwise, it specifies the Subnet IP
166 alaDHCPv6SrvLeaseUtilization-
Threshold
alaDhcpv6Srv-
LeaseThresh-
oldStatus,
alaDHCPv6Srv-
SubnetDe-
scriptor
dhcp v6 This trap is sent when the lease
utilization on a subnet exceeds or
falls below the configured
threshold value.
alaDhcpv6SrvLeaseThresholdStatus—The threshold status of subnet utilization:
• Crossed Below 80 Percent of Threshold
(1)
• Crossed Above 80 Percent of Threshold (2)
• Reached 100 Percent of Threshold (3)
alaDHCPv6SrvSubnetDescriptor—The IPv6 address.
167 smgrServiceStatusChange alaSvcId,
alaSvcType,
alaSvcOperSta-
tus,
alaSvcIsid,
alaSvcBVlan,
alaSvcMulti-
castMode
service
manager
This trap is sent when there is a
change in service operating sta-
tus. A service is operationally up
when it's admin-up and there's at
least one active SAP or one
active bind that is operationally
up.
alaSvcId—The service identifier.
alaSvcType—The service type (e.g., vpls, spb).
alaSvcIsid—The I-Domain Service Indentifier (I-SID), which identifies the service instance in a PBB network
in a BEB switch. For a customer packet flowing to the B-Domain, the I-SID is derived from the VFI and
inserted into the packet. For a packet flowing from the B-Domain, the I-SID is used to identify the VFI for the
I-Domain processing.
alaSvcBVlan—The Backbone VLAN ID (BVLAN), which defines the B-Domain for the PBB traffic.
alaSvcMulticastMode— The multicast replication mode for each service:
• Head-End (1) - where a non-unicast packet entering the SAP port is replicated once for each receiver in the
B-Domain using its unicast BMAC.
• Tandem (2) - where a non-unicast packet entering the SAP port is replicated once at each node using the
multicast group address.
168 smgrSapStatusChange alaSvcId,
alaSapPortId,
alaSapEn-
capValue,
alaSapOperSta-
tus
service
manager
This trap is sent when there is a
change in SAP operating status.
A SAP is operationally up when
it's admin-up and the link status
of the physical or logical port of
the SAP is operationally up.
alaSvcId—The service identifier.
alaSapPortId—The ID of the access port where this SAP is defined.
alaSapEncapValue—The value of the label used to identify this SAP on the access port specified by the SAP
Port ID.
alaSapOperStatus—The operational state of the SAP:
• up (1)
• down (2)
• ingressQosMismatch (3)
• egressQosMismatch (4)
• portMtuTooSmall (5)
• svcAdminDown (6)
• iesIfAdminDown (7)
No. Trap Name Objects Family Description