User guide

SNMP Traps Table
OmniSwitch AOS Release 7 Switch Management Guide March 2015 page B-13
pimGroupMappingPimMode—The PIM mode used for groups in this group prefix.
pimInvalidRegisterAddressType—The address type stored in pimInvalidRegisterOrigin, pimInvalid Regis-
terGroup and pimInvalidRegisterRp. If no unexpected Register messages are received, the onject is set to
“Unknown”.
pimInvalidRegisterOrigin—The source address of the last unexpected Register message received by thisde-
vice
pimInvalidRegisterGroup—The IP multicast group address to which the last unexpected Register message
received by this device was addressed.
pimInvalidRegisterRp—The RP address to which the last unexpected Register message received by this
device was delivered.
46 pimInvalidJoinPrune pimGroupMap-
pingPim-
Mode
pimInvalidJoin-
PruneAd-
dressType
pimInvalidJoin-
PruneOrigin
pimInvalidJoin-
PruneGroup
pimInvalidJoin-
PruneRp
pimNeigh-
borUpTime
ipmr This trap is sent when an invalid
PIM Join/Prune message is
received.
The notification is generated
whenever the PIM Invalid Join
Prune Messages Recieved
counter is incremented, subject to
the rate limit specified by the
PIM Invalid Join/Prune Notifica-
tion Period.
pimGroupMappingPimMode—The PIM mode used for groups in this group prefix.
pimInvalidRegisterAddressType—The address type stored in pimInvalidRegisterOrigin, pimInvalid Regis-
terGroup and pimInvalidRegisterRp. If no unexpected Register messages are received, the onject is set to
“Unknown”.
pimInvalidJoinPruneOrigin—The source address of the last unexpected Join/Prune message received
pimInvalidJoinPruneGroup—The IP multicast group address carried in the last unexpected Join/Prune mes-
sage received
pimInvalidJoinPruneRp—The RP address carried in the last unexpected Join/Prune message received
pimNeighborUpTime—The time since this PIM neighbor (last) became a neighbor of the local router.
47 PimRPMappingChange pimGroupMap-
pingPim-
Mode
pimGroupMap-
pingPrece-
dence
ipmr This trap is sent when a change is
detected to the active RP map-
ping on the device.
The notification is generated
whenever the PIM RP Mapping
Change Count is incremented,
subject to the rate limit specified
by PIM RP Mapping Change
Notification Period
pimGroupMappingPimMode—The PIM mode used for groups in this group prefix.
pimGroupMappingPrecedence—The value for pimGroupMappingPrecedence to be used for this static RP
configuration. This allows fine control over which configuration is overridden by this static configuration
No. Trap Name Objects Family Description