User guide

Working With Configuration Files Creating Snapshot Configuration Files

OmniSwitch AOS Release 7 Switch Management Guide March 2015 page 6-9

Creating Snapshot Configuration Files

You can generate a list of configurations currently running on the switch by using the configuration

snapshot command. A snapshot is a text file that lists commands issued to the switch during the current

Note. A user must have read and write permission for the configuration family of commands to generate a

snapshot file for those commands. See the “Switch Security” chapter of this manual for further informa-

tion on permissions to specific command families.

Snapshot Feature List

You can specify the snapshot file so that it will capture the CLI commands for one or more switch features

or for all network features. To generate a snapshot file for all network features, use the following syntax:

-> configuration snapshot all

To generate a snapshot file for specific features, select the appropriate syntax from the following list.

You may enter more than one network feature in the command line. Separate each feature with a space

(and no comma). The following command will generate a snapshot file listing current configurations for

the vlan, qos, and snmp command families.

-> configuration snapshot vlan qos snmp

Snapshot Keywords

WEBMGT QOS IPSEC

VRRP PORT-MAPPING IPMS

VLAN POLICY IPMR

VFC PMM IP-ROUTING

UDLD OSPF3 IP-HELPER

SYSTEM OSPF IP

STP NTP INTERFACE

STACK-MANAGER NETSEC HEALTH

SNMP MULTI-CHASSIS ERP

SLB MODULE CHASSIS

SESSION LLDP CAPABILITY

RIPNG LINKAGG BFD

RIP BGP AAA

BRIDGE IPV6 ALL