User guide

Working With Configuration Files Quick Steps for Applying Configuration Files
OmniSwitch AOS Release 7 Switch Management Guide March 2015 page 6-5
Note. Optional. To verify that the switch received this configuration apply request, enter the
show configuration status command. The display is similar to the one shown here.
-> show configuration status
File configuration <bncom_cfg.txt>: scheduled at 07/04/10 09:00
Error file limit: 1
Running configuration and saved configuration are different
For more information about this display see “Configuration File Manager Commands” in the OmniSwitch
AOS Release 7 CLI Reference Guide.
Setting an Application Session for a Specified Time Period
You can set a future timed session to apply a configuration file after a specified period of time has elapsed.
In the following example, the amzncom_cfg.txt will be applied after 6 hours and 15 minutes have
elapsed.
1 Verify that there are no current timer sessions pending on the switch.
-> show configuration status
File configuration: none scheduled
2 Apply the file by executing the configuration apply command using the in keyword with the relevant
time frame specified.
-> configuration apply amzncom_cfg.txt in 6:15
Note. Optional. To verify that the switch received this configuration apply request, enter the
show configuration status command. The display is similar to the one shown here.
-> show configuration status
File configuration </flash/working/amzncom_cfg.txt>: scheduled at 03/07/10 05:02
The “scheduled at” date and time show when the file will be applied. This value is 6 hours and 15 minutes
from the date and time the command was issued.
For more information about this display see “Configuration File Manager Commands” in the OmniSwitch
AOS Release 7 CLI Reference Guide.