User guide

Working With Configuration Files Tutorial for Creating a Configuration File
OmniSwitch AOS Release 7 Switch Management Guide March 2015 page 6-3
For more information about these displays, refer to the OmniSwitch AOS Release 7 CLI Reference Guide.
5 Use the show ip helper command to verify that the DHCP Relay parameters defined in the configura-
tion files were actually implemented on the switch. The display is similar to the one shown here:
-> show ip helper
Ip helper :
Forward Delay(seconds) = 15,
Max number of hops = 3,
Relay Agent Information = Disabled,
PXE support = Disabled,
Forward option = standard mode,
Bootup Option = Disable
Forwarding address list (Standard mode):
192.168.10.10
These results confirm that the commands specified in the file dhcp_relay.txt configuration file were
successfully applied to the switch.