User guide

Configuring OSPFv3 OSPFv3 Defaults Table
OmniSwitch AOS Release 7 Advanced Routing Configuration Guide March 2015 page 2-3
OSPFv3 Defaults Table
The following table shows the default settings of the configurable OSPFv3 parameters.
Parameter Description Command Default Value/Comments
Configures the OSPFv3 administra-
tive status.
ipv6 ospf admin-state enabled
Configures the administrative status
for an OSPF interface.
ipv6 ospf interface admin-state enabled
Configures OSPFv3 redistribution. ipv6 redist disabled
Configures timers for Shortest Path
First (SPF) calculation.
ipv6 ospf spf-timer delay: 5
hold: 10
Creates or deletes an area default
metric.
ipv6 ospf area 0
Configures OSPFv3 interface dead
interval.
ipv6 ospf interface dead-interval 40 seconds
Configures OSPFv3 interface hello
interval.
ipv6 ospf interface hello-interval 10 seconds
Configures the OSPFv3 interface
cost.
ipv6 ospf interface cost 1
Configures the OSPFv3 interface
priority.
ipv6 ospf interface priority 1
Configures OSPFv3 interface
retransmit interval.
ipv6 ospf interface retrans-inter-
val
5 seconds
Configures the OSPFv3 interface
transit delay.
ipv6 ospf interface transit-delay 1 second