User guide

Configuring IPv6 PIM Configuring PIM
page 7-36 OmniSwitch AOS Release 7 Advanced Routing Configuration Guide March 2015
-> ipv6 pim sparse admin-state enable
To globally enable IPv6 PIM-Dense Mode on the switch, use the ipv6 pim dense admin-state command.
Enter the command syntax as shown below:
-> ipv6 pim dense admin-state enable
Disabling IPv6 PIM Mode on the Switch
To globally disable IPv6 PIM-Sparse Mode on the switch, use the ipv6 pim sparse admin-state
command. Enter the command syntax as shown below:
-> ipv6 pim sparse admin-state disable
To globally disable IPv6 PIM-Dense Mode on the switch, use the ipv6 pim dense admin-state command.
Enter the command syntax as shown below:
-> ipv6 pim dense admin-state disable
Checking the Current Global IPv6 PIM Status
To view the current global IPv6 PIM status, as well as additional global IPv6 PIM settings, use the show
ip pim sparse or show ip pim dense command. For example:
-> show ipv6 pim sparse
Status = enabled,
Keepalive Period = 210,
Max RPs = 32,
Probe Time = 5,
Register Suppress Timeout = 60,
RP Switchover = enabled,
SPT Status = enabled,
-> show ipv6 pim dense
Status = enabled,
Source Lifetime = 210,
State Refresh Interval = 60,
State Refresh Limit Interval = 0,
State Refresh TTL = 16