User guide

Quick Steps for Configuring IPv6 PIM-DM Configuring PIM
page 7-34 OmniSwitch AOS Release 7 Advanced Routing Configuration Guide March 2015
-> show ipv6 pim sparse
Status = enabled,
Keepalive Period = 210,
Max RPs = 32,
Probe Time = 5,
Register Suppress Timeout = 60,
RP Switchover = enabled,
SPT Status = enabled,
The display for dense mode is similar to the one shown here:
-> show IPv6 pim dense
Status = enabled,
Source Lifetime = 210,
State Refresh Interval = 60,
State Refresh Limit Interval = 0,
State Refresh TTL = 16
(additional table output not shown)
For more information about these displays, see the “PIM Commands” chapter in the OmniSwitch AOS
Release 7 CLI Reference Guide.